Universal-remote-control-urs WR7 Manuel d'utilisateur télécharger pdf (Page 30)

Page 30

Erasing Commands -

Overview

You can erase a single learned command, all

learned commands in each component mode,

SimpleSound programming, MacroPower com-

mands, or re--set the remote to original factory

default settings.

Erasing a Single Learned Command from

One Component

STEP 1: Press the component button where

the learned command is stored and the [ENTER]

button at the same time for two seconds until the

component LED light turns on.

IMPORTANT: You have 30 seconds to per-

form the next step while you are in programming

mode. If you do not press a button within 30 sec-

onds, the component LED light will turn off. The

remote will exit the programming mode and you

will have to start over.

STEP 2: Press and hold the button you

want to erase for two seconds. The compo-

nent LED light will blink twice to confirm the

erasure.

STEP 3: Repeat Step 2 to erase any other

buttons in the selected component mode.

STEP 4: To exit Erase mode, press and

hold both the component button and the

[ENTER] button at the same time until the

component LED light blinks three times.

COMPONENT

BUTTONS

ENTER

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 51 52

Pas de commentaire

Universal-remote-control-urs WR7 Manuel d'utilisateur Page 30